crwdns2915892:0crwdne2915892:0
This guide describes how to replace the Black and Decker PS1800 switch. A soldering gun is necessary to replace the switch. Personal protective equipment is suggested.
crwdns2942213:0crwdne2942213:0
-
-
Lay the drill on its side, assuring that the screw holes are facing upwards.
-
Remove seven 12 mm screws using a Phillips #00 screwdriver.
-
-
-
Separate the outer drill case to expose the components and switch.
-
-
-
-
Identify the switch in center of the drill.
-
Remove the screws from the switch.
-
Remove the switch cover.
-
-
-
Locate the switch inside the drill.
-
Remove the switch from the drill.
-
-
-
Solder off all the joints.
-
Remove the switch assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0