crwdns2915892:0crwdne2915892:0
If the light in the drill is not glowing upon use, then this guide will show a step by step process on how to replace the light bulb for the drill.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four screws on the back top side of the drill.
-
-
-
Remove the four screws that connect the chuck to the drill.
-
-
-
Remove the five screws on the front side of the drill.
-
-
-
Gently grab both sides of the drill casing, and separate both sides from each other.
-
-
-
-
At this point you should be able to separate both as illustrated.
-
-
-
After following the prerequisite guide the drill is now open and you can see all the components of the drill.
-
-
-
First separate the top part of the drill, which includes the motor and the chuck, from the rest of the components.
-
-
-
Then separate the other component which includes the trigger, light, and the connection to the battery.
-
-
-
First check if the connection to the light is not intact.
-
If the wiring is lose simply reconnect the wire.
-
Then check if the light bulb is not damaged in any way.
-
If the light bulb is broken or simply just burnt; simply replace the light bulb.
-
-
-
Grab the connection of the light bulb.
-
-
-
Using pliers cut the two connecting wires from the mother chip.
-
To prevent potential damage to the component, try desoldering the wires. Learn more about soldering here.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 11-5, Cheng Spring 2016 crwdns2935289:0USF Tampa, Team 11-5, Cheng Spring 2016crwdne2935289:0
USFT-CHENG-S16S11G5
crwdns2931471:05crwdne2931471:0
crwdns2935297:06crwdne2935297:0
