crwdns2915892:0crwdne2915892:0
Full Device Name: Black and Decker 3-in-1 Grill - Griddle - Waffle Maker
Model Name: G48TD
This guide aims to disassemble the device into its fundamental components.
Safety warnings:
- Do not operate on device while it is receiving power
- Be careful when bending sharp metal tabs
No special skills are required for following this guide
crwdns2942213:0crwdne2942213:0
-
-
Remove the top and bottom griddle plates.
-
-
-
Use a pair of Large Needle Nosed Pliers to twist the metal tabs holding the plate housing the bottom heating element connections and remove the plate.
-
-
-
Use a pair of Large Needle Nosed Pliers to twist the metal tabs holding the plate housing the top heating element connections and remove the plates.
-
-
-
Use pliers to twist the metal tabs holding down the thermostat housing.
-
-
-
-
Use a 4 mm Flathead screwdriver to remove the 11.4 mm screw in the back of the thermostat housing.
-
-
-
Lift up the thermostat housing and detach it from the temperature control arm, then remove the washers at the end of the temperature control arm.
-
-
-
Remove the thermostat housing springs.
-
-
-
Bend up the brackets holding down the heating elements.
-
-
-
Remove the heating elements from their respective housings (the bottom one is not able to be removed completely as it is fused to a piece of metal).
-
-
-
Remove the housing from the wiring along the bottom of the grill.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Tufts University School of Engineering, Team 1-7, Bell Fall 2021 crwdns2935289:0Tufts University School of Engineering, Team 1-7, Bell Fall 2021crwdne2935289:0
TUFTS-BELL-F21S1G7
crwdns2931471:02crwdne2931471:0
crwdns2935303:01crwdne2935303:0
