crwdns2915892:0crwdne2915892:0
This guide shows users how to replace the motor in the Black and Decker Dustbuster Handheld Vacuum (Model No. HNVC115J22 ). If your vacuum doesn’t run and you suspect the motor is the problem, you could replace it. Replacing the motor may restore suction power back to your device; make sure that another part is not at fault instead of the motor before replacing it. This device contains a lithium battery, so be careful not to short it or damage it. A new motor will need to be purchased for this guide.
crwdns2942213:0crwdne2942213:0
-
-
Press the button above the dustbin and separate the dustbin from the handle.
-
-
-
Remove five screws from the handle using a Phillips #1 screwdriver.
-
-
-
-
Lift the motor and circuitry out of the plastic casing using your hands.
-
Pry out the PCB using a nylon spudger.
-
-
-
Separate the motor leads from the PCB with a pair of needle nose pliers.
-
-
-
Using a pair of pliers, insert the metal prongs of the new motor into the PCB.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Embry-Riddle Aeronautical University, Team 1-8, Rauch Fall 2021 crwdns2935289:0Embry-Riddle Aeronautical University, Team 1-8, Rauch Fall 2021crwdne2935289:0
ERAU-RAUCH-F21S1G8
crwdns2931471:02crwdne2931471:0
crwdns2935303:01crwdne2935303:0
