crwdns2915892:0crwdne2915892:0
This guide provides information on how to remove and replace the Power Cord of the BLACK and DECKER BDERO100 5 inch sander. The tools that you will need for this process is the JIS - J1 bit driver or equivalent, the TR20 Torx Security bit driver or equivalent, the plastic spudger & the plastic opening tool.
crwdns2942213:0crwdne2942213:0
-
-
Use the nylon spudger to remove the rubber ring from the filter attachment section.
-
-
-
Use the TR20 Torx Security bit driver to unscrew the five 18.75mm Phillips screws from the warning label side of the chassis.
-
-
-
Grab the plastic opening tool and place it on the separation line between both sides of the chassis.
-
Separate both sides and open the device.
-
-
-
Hold the chassis and separate it from the device.
-
-
-
-
Use the bit driver with the JIS - J1 bit to remove the two 12.5 mm phillips screws holding the cord clamp to the chassis.
-
-
-
Gently pull the white cable that connects the power cord to the motor to detach it.
-
-
-
With yout hands, hold and separate the power button from the external case by pulling gently.
-
-
-
Select the cable that connects the power button to the power button.
-
-
-
Expose the cable and lock system by removing the cover.
-
-
-
Push the security pin with the plastic spudger and simultaneously, pull gently on the cable to separate it from the button.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0