crwdns2915892:0crwdne2915892:0
Before diving into the replacement of your drill power cord, it will be helpful to know that this is a fairly easy replacement with few steps and few tools. Remember to disconnect the power cord from a wall outlet before disconnecting any wires.
crwdns2942213:0crwdne2942213:0
-
-
To detach the matrix attachment piece, press down on the attachment release button located at the top of the device.
-
Leaving your finger pressed down on the button, simply pull on the attachment to release it.
-
-
-
Using a JIS 1 screwdriver, unscrew seven 19mm outer screws located on the armature.
-
Using the same screwdriver, unscrew the 12mm outer screw located on the armature.
-
-
-
-
Using the T-handle screwdriver with the JIS 1 bit, unscrew the two lower black 12mm screws.
-
-
-
There will be a white cord that runs from the power cord base to the circuit board located slightly above.
-
Use the tweezers to detach the entire white cord and blue connection piece as a whole from the circuit board.
-
-
-
Physically pull up on the trigger device and remove it from the armature.
-
Flip trigger device over onto its back.
-
-
-
There is a screw labeled 3 located on the bottom left of the back of the trigger device.
-
Use a JIS 0 screwdriver to remove screw.
-
Gently tug on the black wire to pull the wire out of the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UW Tacoma, Team 1-2, Rose Winter 2016 crwdns2935289:0UW Tacoma, Team 1-2, Rose Winter 2016crwdne2935289:0
UWT-ROSE-W16S1G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:011crwdne2935297:0
