crwdns2915892:0crwdne2915892:0
Is your Bissell SpotClean ProHeat 5207U spray trigger difficult to use? It could be because of a failing spray mechanism. Follow this guide to replace the spray mechanism for your Bissell SpotClean ProHeat 5207U.
crwdns2942213:0crwdne2942213:0
-
-
Place the brush in front of you and make sure that the brushes are rotated towards the ceiling.
-
Separate the brush from the hose by pressing the lever.
-
-
-
Using a Phillips screwdriver, unscrew the two 12.8 mm screws on the lever cap.
-
Remove the cap on top of the spring mechanism.
-
-
-
-
Grab the spraying mechanism and separate it from the lever by pulling it back.
-
Rotate the spraying mechanism clockwise to fully separate it.
-
-
-
Grab the spring mechanism and pull back to fully loosen it.
-
-
-
Using tweezers, squeeze the hose clamp prongs together to loosen it.
-
As you are squeezing the hose clamp prongs, pull the spraying mechanism out to remove it.
-
Once the spraying mechanism is removed, and squeeze the clamp prongs again and install the new mechanism.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
University of North Texas, Team 6-4, Kilpatrick Fall 2023 crwdns2935289:0University of North Texas, Team 6-4, Kilpatrick Fall 2023crwdne2935289:0
UNT-KILPATRICK-F23S6G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
