crwdns2915892:0crwdne2915892:0
Follow these instructions to remove the throttle cable, either to replace it or to service the throttle control.
crwdns2942213:0crwdne2942213:0
-
-
Cut and remove any zip ties securing the throttle cable.
-
-
-
Use a Phillips #2 driver to remove the screw securing the lower end of the throttle cable.
-
-
-
Remove the bracket securing the lower end of the throttle cable.
-
-
-
-
Rotate the lower end of the throttle cable to detach it from the throttle.
-
-
-
If necessary, loosen the screw securing the lower end of the throttle cable and adjust the position of the cable. Re-tighten the screw and check to make sure that the throttle moves through its full range of motion.
-
-
-
Use a 7/16" wrench or deep socket to remove the cap from the throttle control.
-
-
-
Advance the throttle control to expose the gear rack containing the upper end of the throttle cable.
-
-
-
Separate the gear rack from the upper end of the throttle cable.
-
Lift and remove the gear rack from the throttle control.
-
If the gear rack doesn't fully detach, advance the throttle control lever a little farther.
-
-
-
Use a 1/2" wrench to unscrew the upper end of the throttle cable from the throttle control.
-
Slide the throttle cable down out of the bottom of the throttle control, and remove the cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
