crwdns2915892:0crwdne2915892:0
Instructions for removing the rear guard/cover to access internal components for service.
crwdns2942213:0crwdne2942213:0
-
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
Use a 1/2" socket or wrench to remove the two 26 mm bolts securing the rear guard to the back end of the brush cutter.
-
-
-
-
Raise and support the back end of the brush cutter—or tip it carefully onto its side—in order to access the bottom cover.
-
-
-
Use a 3/8” socket or wrench to remove the four 21 mm bolts securing the rear guard.
-
Remove the guard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0