crwdns2915892:0crwdne2915892:0
In this guide you will be taking apart the Bell and Howell DNV16HDZ camera to replace the lens. There are different lens types that you can replace it with.
crwdns2942213:0crwdne2942213:0
-
-
Remove the five 30mm Phillips #0 screws on the bottom of the camera.
-
-
-
Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.
-
-
-
-
It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.
-
-
-
Take out the two 20 mm screws that attach it to the shutter.
-
-
-
Remove the ten 30 mm Phillips #0 screws from the front lens.
-
-
-
Take the shutter screen parts out of the lens.
-
Now push out the front lens.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team 8-4, Botvin Spring 2016 crwdns2935289:0UMass Dartmouth, Team 8-4, Botvin Spring 2016crwdne2935289:0
UMASSD-BOTVIN-S16S8G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:012crwdne2935297:0
