crwdns2915892:0crwdne2915892:0
This guide walks you through how to replace the switch cover on the NetCam.
crwdns2942213:0crwdne2942213:0
-
-
Use a wrench to loosen up the stand from the back in order to hold the NetCam more comfortably.
-
-
-
Work a plastic opening tool into the seam and pry the face plate away from the back panel.
-
-
-
-
Carefully use your fingers to gently pull out the white attachment from the tan colored part.
-
-
-
Use a Phillips #0 screwdriver to take out the two 1.2 mm screws on the board.
-
-
-
With your fingers, pull the circuit board out of the back casing.
-
-
-
Gently pull the speaker out of the holder from the back of the cover.
-
-
-
The speaker wires are attached with the board. It can be unattached gently by pulling out the white attachment from the port.
-
-
-
On the back of the board pull the switch slowly upward to take it off.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0