crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Bear 1000 Filter Replacement

crwdns2911024:0crwdne2911024:0
crwdns2911026:0crwdne2911026:0

crwdns2915892:0crwdne2915892:0

This guide will walk you through the process of replacing the ambient air intake filters in a Bear 1000 Ventilator. Found on page 97 in the full service manual.

crwdns2942213:0crwdne2942213:0

    • Turn off the ventilator and disconnect from AC power and pressurized gas at the wall sources.

    crwdns2913378:0crwdne2913378:0

  2. Bear 1000 Filter Replacement: crwdns2935265:02crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Open the ventilator by removing the console retaining screw.

    crwdns2913378:0crwdne2913378:0

    • Vacuum all surfaces inside the ventilator. Be sure to reach areas around connectors, circuit boards and pneumatic assembies.

    crwdns2913378:0crwdne2913378:0

    • Remove old filters in back panel and replace with new ones.

    crwdns2913378:0crwdne2913378:0
crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order.

crwdns2862417:0crwdne2862417:0

crwdns2935293:0crwdnd2935293:02crwdnd2935293:0crwdne2935293:0

Eli Ferman

crwdns2935283:004/08/20crwdne2935283:0

607 crwdns2915208:0crwdne2915208:0

crwdns2935297:04crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 7

crwdns2935301:04crwdne2935301:0

crwdns2915084:0crwdne2915084:0

Cal Poly, Team S7-G12, Paton Fall 2020 crwdns2935289:0Cal Poly, Team S7-G12, Paton Fall 2020crwdne2935289:0

CPSU-PATON-F20S7G12

crwdns2931471:02crwdne2931471:0

crwdns2935297:06crwdne2935297:0

crwdns2947412:00crwdne2947412:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 0

crwdns2936753:07crwdne2936753:0 0

crwdns2936753:030crwdne2936753:0 3

crwdns2942667:0crwdne2942667:0 111