crwdns2933423:0crwdne2933423:0

Bear 1000 Air and O2 Blender Replacement

crwdns2911024:0crwdne2911024:0
crwdns2911026:0crwdne2911026:0

crwdns2942213:0crwdne2942213:0

  1. Bear 1000 Air and O2 Blender Replacement, Air and O2 Blender: crwdns2935265:01crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
    • Remove the ribbon cable at the connection on the oxygen blender control board.

  2. Bear 1000 Air and O2 Blender Replacement: crwdns2935265:02crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
    • Mark the plastic hoses attached to the oxygen blender (so you can put them back on the same way) and then remove.

  3. Bear 1000 Air and O2 Blender Replacement: crwdns2935265:03crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
    • The air/oxygen blender has two screws close to the control board. Remove them and remove the unit.

crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order. Perform an OVP test to check proper installment.

NOTE: do not interchange control boards with non-socketed ones!

crwdns2935227:0crwdne2935227:0

William Burns

crwdns2935283:004/06/20crwdne2935283:0

285 crwdns2915208:0crwdne2915208:0

crwdns2935297:02crwdne2935297:0

crwdns2915084:0crwdne2915084:0

Cal Poly, Team S7-G12, Paton Fall 2020 crwdns2935289:0Cal Poly, Team S7-G12, Paton Fall 2020crwdne2935289:0

CPSU-PATON-F20S7G12

crwdns2931471:02crwdne2931471:0

crwdns2935297:06crwdne2935297:0

crwdns2947412:00crwdne2947412:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 0

crwdns2936753:07crwdne2936753:0 3

crwdns2936753:030crwdne2936753:0 10

crwdns2942667:0crwdne2942667:0 258