crwdns2915892:0crwdne2915892:0
Prereq-only guide for disconnecting the battery.
crwdns2942213:0crwdne2942213:0
-
-
Remove the eight 4 mm T5 Torx screws from the bottom cover.
-
-
-
Use a plastic opening tool to pry open the 'XPS' flap in the middle.
-
-
-
-
Remove the single Phillips screw hidden beneath the flap.
-
-
-
Use opening picks or a plastic pry tool to pry open the case clips, beginning from the back edge.
-
-
-
Pull the battery cable connector towards the battery to disconnect it from its socket.
-
If the connector is stubborn, push a little at one side, then the other, to "walk" it out of its socket.
-
If you have trouble walking the connector out of the socket, use the point of a spudger to gently push on the connector indent to slide the connector out.
-
Open the display and press the power button for five seconds to drain any remaining charge from the system.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
