crwdns2915892:0crwdne2915892:0
This is a prerequisite-only guide! This guide is part of another procedure and isn't meant to be used alone.
crwdns2942213:0crwdne2942213:0
-
-
Use a T5 Torx screwdriver to remove the six 7.2 mm screws securing the lower case.
-
-
-
Insert an opening pick between the lower case and the chassis at a hinge corner.
-
Pry up with the pick to release the clips securing the lower case.
-
Repeat the process on the other hinge corner.
-
-
-
Slide the pick along the right edge to release the clips securing the lower case.
-
-
-
-
Continue sliding the opening pick along the front and left edges to release the remaining clips.
-
-
-
Insert the pick on the hinge edge and slide along the entire edge to release all of the clips.
-
-
-
Lift the lower case from the chassis and remove it.
-
-
-
Use the pointed end of a spudger to push each side of the battery connector until it comes out of the socket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
