crwdns2915892:0crwdne2915892:0
Prereq for disconnecting the battery of your Samsung Galaxy A10.
crwdns2942213:0crwdne2942213:0
-
-
Insert a SIM card eject tool, a SIM eject bit or a straightened paper clip into the hole on the SIM tray located at the left side of the phone.
-
Press firmly to eject the tray.
-
-
-
Insert an opening pick between the screen and the back cover on the bottom of the phone where the charging port is located.
-
-
-
Slide the opening pick to the bottom left corner to release the clips.
-
-
-
-
Slide the opening pick along the left edge to the top left corner of the phone, to release the clips.
-
-
-
Slide the opening pick from the top left corner to the top right corner to release the plastic clips.
-
-
-
Slide the opening pick from the top left corner to the bottom right corner to release the remaining clips.
-
-
-
Remove the three Phillips #00 screws (3 mm length).
-
-
-
Use the flat end of a spudger to pry up the motherboard cover to release the plastic clips which hold the cover in its place.
-
Remove the motherboard cover.
-
-
-
Use a spudger to disconnect the battery by prying the connector straight up from its socket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
