crwdns2915892:0crwdne2915892:0
This guide will teach you how to open up a BaByliss i-Pro 45 to change its batteries.
3x AAA 1.2V batteries with U-lips are required to be soldered onto the motherboard.
Opening up the device is an ideal opportunity to thoroughly clean it. Under the head/blades, some hairs may be stuck.
crwdns2942213:0crwdne2942213:0
-
-
Remove the rubber plug hiding the screw
-
Remove the screw under the plug
-
Remove two screws below the blades with a long Philips screwdriver
-
-
-
Remove the screws at the bottom of the blade
-
Remove the blade
-
-
-
-
Gently open the housing
-
-
-
open the plastic parts holding the circuit in place
-
start lifting from the tail
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:09crwdne2935229:0
crwdns2944067:011crwdne2944067:0
Use low self-discharge NiMHs and it will make you angry many years.
Design of this cutter is faulty - it tugs your hair when you try to cut too much or too fast.
Personally, I have been using this hair clipper for many years and it works perfectly well. Today I have to replace the battery. Can anyone tell me what the battery model is and if I need to use a soldering iron to replace it?
It is mentioned above:
3x AAA 1.2V batteries with U-lips are required to be soldered onto the motherboard.
So yes, a soldering iron is required, and the battery must have lips (i.e. not the standard AAA batteries you can find in any shop).
Fuss -
