crwdns2915892:0crwdne2915892:0
The Blu Life XL can have issues with the speaker. Follow this guide to replace the speaker and enjoy crystal clear audio.
crwdns2942213:0crwdne2942213:0
-
-
Turn the device off by holding down the power button for up to 5 seconds and then tapping the "Power off" button on the screen.
-
Remove the rear cover using your hands at the lip on the device back cover. No tools required.
-
Remove the battery by lifting the lower edge of the battery up first.
-
-
-
Remove twelve 2.1mm Phillips #000 screws from the rear plate.
-
-
-
-
Use an opening tool to separate the rear plate from the phone.
-
Firmly press the opening tool into the gap between the front glass and rear plate. This gap is located on all sides of the phone.
-
If the opening tool is not working, try using your fingernails on the side of the phone. Once a small area of the rear plate is released, continue to use the opening tool.
-
Run the opening tool around the entire phone separating the rear plate from the frame.
-
-
-
Gently flip the tan cable lock back to release the ribbon cable from the lower PCB Board.
-
Using a spudger, gently pull the ribbon cable from its socket.
-
Remove the 3mm screw from the PCB using a Phillips #000 screwdriver.
-
-
-
Locate the speaker and connected haptic motor on the lower PCB of the phone.
-
Using an opening tool, lightly pry around all edges of the PCB until it releases from the adhesive backing.
-
Use the same process as above to remove the Haptic motor. It has the black and red wire connected to it and the PCB.
-
crwdns2915084:0crwdne2915084:0
USF Tampa, Team S2-G5, Eyestone Spring 2018 crwdns2935289:0USF Tampa, Team S2-G5, Eyestone Spring 2018crwdne2935289:0
USFT-EYESTONE-S18S2G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
