crwdns2915892:0crwdne2915892:0
A hands on guide to replacing the touch screen on the Blu Dash 3.5. This guide will detail the steps necessary to remove and replace the touch screen.
crwdns2942213:0crwdne2942213:0
-
-
Start by locating the slot on the lower right corner of the device.
-
Insert the opening tool into the slot.
-
Pry the back cover off. Once the corner is off, continue around the perimeter of the phone pulling the back off with your fingers.
-
-
-
Locate the indentation at the bottom of the battery.
-
Insert your thumb and pull the battery out.
-
-
-
-
Use the 000 Phillips screwdriver to remove the four 4.5 mm screws from the corners of the interior back panel.
-
Use the opening tool to pry open the plastic back panel to expose the motherboard.
-
-
-
Remove volume and lock buttons by lifting them gently from the casing.
-
-
-
Use tweezers to lift the tab where the cable is connected.
-
Use the opening tool to pry the motherboard from the front face plate.
-
-
-
Use opening tool to pry off the screen.
-
Use a soldering tool to melt the contact between the motherboard and the screen
-
Solder new screen contacts to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Ohio State, Team 1-2, Garvin Fall 2015 crwdns2935289:0Ohio State, Team 1-2, Garvin Fall 2015crwdne2935289:0
OSU-GARVIN-F15S1G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:02crwdne2935297:0
