crwdns2915892:0crwdne2915892:0
This guide provides information on how to remove and replace the hook and loop system of the BLACK and DECKER BDERO100 5 inch sander. The only tool that you will need for this process is the JIS - J1 bit or equivalent.
crwdns2942213:0crwdne2942213:0
-
-
Remove the sanding paper from the velcro.
-
-
-
Select the JIS - J1 bit or the most appropriate bit to match the screws for your model.
-
-
-
-
Use the Bit Driver to take off the four 12.5 mm Phillips screws at the base of the hook-and-loop system.
-
-
-
Once all screws and washers have been removed, hold the hook and loop system and separate it from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 1-5, Sullivan Spring 2016 crwdns2935289:0USF Tampa, Team 1-5, Sullivan Spring 2016crwdne2935289:0
USFT-SULLIVAN-S16S1G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
