crwdns2915892:0crwdne2915892:0
Before starting this guide you may need some experience with soldering/ desoldering. If you do not know how, you can learn by clicking the link we put on step 8 (when you have to desolder the backlight).
crwdns2942213:0crwdne2942213:0
-
-
Before disassembling your Atari Lynx, be sure the device is powered off.
-
Remove any game in the console by opening the right latch and sliding the game to the right.
-
-
-
Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.
-
Pinch the rear panel with your fingers and lift away from the Atari.
-
-
-
Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.
-
-
-
-
Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.
-
-
-
Pull out the logic-board.
-
Pull to the sides the four rubber tabs holding in the screen
-
-
-
Unscrew the two 10 mm screws as shown with a Phillips #0 screwdriver in order to remove the shield behind the backlight.
-
-
-
Flip over the motherboard and remove the shield behind the backlight.
-
-
-
Flip the motherboard back over and desolder the two components that are holding the backlight in place.
-
If you need help with basic desoldering, click here.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 1-42, Maness Winter 2014 crwdns2935289:0Cal Poly, Team 1-42, Maness Winter 2014crwdne2935289:0
CPSU-MANESS-W14S1G42
crwdns2931471:05crwdne2931471:0
crwdns2935297:016crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Good instructions but my Atari is different
