crwdns2915892:0crwdne2915892:0
If your Asus Zenbook UX31E laptop has stiff or unresponsive keys, use this guide to replace the keyboard.
The keyboard inputs character data to the laptop through key presses called keystrokes. Faulty keys may cause unregistered keystrokes with no input of character data. An on-screen keyboard available through Windows or an external USB keyboard may be used until internal keyboard issues are resolved.
Before starting a repair, make sure to power off your device completely and disconnect from any external power source.
crwdns2942213:0crwdne2942213:0
-
-
Using a T4 Torx screwdriver, remove the ten screws at the marked locations.
-
-
-
Carefully slide your iFixit Opening Tool between the back panel.
-
Lift the back plate of your ASUS ZenBook UX31E, and place it to the side.
-
-
-
Disconnect the battery from the motherboard by gently pulling up and down on the connector.
-
-
-
Using the Phillips #00 screwdriver, remove the screws from the middle and the two corners of the battery.
-
-
-
Remove the battery. (Picture-1)
-
Picture of what the battery looks like.(Picture-2)
-
-
-
Use the plastic opening tool to pry open the back cover of the laptop.
-
Remove the bottom panel of the laptop.
-
-
-
Remove the screw connecting the speaker component to the motherboard using the screwdriver.
-
-
-
-
Disconnect the sound cable from the motherboard.
-
-
-
Using the plastic opening tool, pry open the speaker component from the computer.
-
-
-
Peel back the warranty sticker to reveal the screw under it.
-
Using your Phillips #00 Precision Screwdriver, unscrew the screw that you just revealed.
-
-
-
Using your hand, pull the SSD out from its slot.
-
-
-
Disconnect the ribbon between the IO and the motherboard on both sides.
-
-
-
Disconnect the fan connector from the motherboard.
-
Pull up the clips on the ribbon connectors.
-
-
-
Unscrew the two screws that are across each other.
-
-
-
Using a plastic opening tool, lift the fan off of the laptop.
-
You can now use your hands and carefully pull the fan off the laptop.
-
-
-
Remove the 7 screws holding the motherboard in the case with a Phillips #00 screwdriver.
-
Remove the press fit connector attaching the motherboard to the screen.
-
Remove the two cables that are still attached to the motherboard. You will need to use needle nose tweezers to remove these.
-
-
-
Lift gently and flip the motherboard over in the direction of the track pad.
-
Peel off the the yellow tape.
-
Detach the ZIF connector on the underside of the motherboard connecting it to the keyboard.
-
Remove the motherboard.
-
-
-
Remove the speaker assembly.
-
-
-
Gently peel back the yellow tape to reveal where the ribbon cable attaches to the track pad.
-
-
-
Remove the 56 screws marked in red circles using a Phillips #000 screwdriver.
-
-
-
Put your hand under the keyboard and gently push the keyboard up and away from the frame of the computer with your fingers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
The Citadel Military College of South Carolina, Team S2-G4, Eggleston Fall 2019 crwdns2935289:0The Citadel Military College of South Carolina, Team S2-G4, Eggleston Fall 2019crwdne2935289:0
CMCSC-EGGLESTON-F19S2G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
