crwdns2915892:0crwdne2915892:0
Use this guide to replace the RAM in your device.
crwdns2942213:0crwdne2942213:0
-
-
Lift up the rubber tab located in the upper-right corner of the backing plate.
-
-
-
Use a Phillips #1 screwdriver to remove the 5.2 mm screw behind the rubber tap.
-
-
-
Carefully pull the backing plate off. If you have a pry tool, you can pry on the edges carefully.
-
-
-
Use a Phillips #1 screwdriver to remove the 5mm screw on the right side.
-
-
-
-
Pull out the optical drive to revel the screws holding the laptop cover.
-
-
-
Remove all 10 5.2mm Phillips screws holding the main back cover using the Phillips #1 screwdriver.
-
-
-
Remove the four 5.2mm screws directly behind the backing plate using the Phillips #1 screwdriver.
-
-
-
Flip over the laptop and pry the 2 vent covers off.
-
-
-
Remove the two 6.8mm Phillips screws directly below the vent covers using the Phillips #1 screwdriver.
-
-
-
Pry along the edges of the keyboard to lift it up.
-
-
-
Disconnect all 4 ribbon connectors with a tweezer.
-
-
-
Carefully, pull on the side tabs to release the RAM card.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.