crwdns2915892:0crwdne2915892:0
Removing the top cover is a mandatory step before to access the keyboard screw and go deeper inside the Eee PC 1215N.
crwdns2942213:0crwdne2942213:0
-
-
Turn the power off and turn the netbook upside down.
-
Slide both battery catches together to release the battery.
-
Slide the battery out.
-
-
-
Locate the memory compartment.
-
Using a Plastic Opening Tools, remove the screw rubber cover.
-
Remove the screw.
-
-
-
Use a Plastic Opening Tools near the screw hole to release the cover.
-
Remove the cover
-
-
-
-
Using a Spudger, push both right and left metal clip to release one of the RAM module.
-
Slide out the RAM module.
-
Do the same with the second RAM module if necessary.
-
-
-
Remove the screws as necessary.
-
For top cover removing, only remove the 2 bottom screws.
-
The one short screw paterns to uper left screw hole directly on the PCB.
-
-
-
Use a Plastic Opening Tools to release the top cover.
-
Start from the left side.
-
Go around on the bottom
-
Finish with the right side.
-
-
-
Carefully slide the top cover to the bottom in order to see the touchpad connector on the PCB.
-
Use a Spudger to slide the conector attachment black part and release the ribbon from the PCB.
-
Now you can remove the top cover
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2917034:0crwdne2917034:0
Unrelated. My Asus VX-6 recently had the blue USB 3.0 ports stop working. Now the Ethernet connection is intermittent, goes away, come back, over and over again. Are those 3 ports on the right hand side part of the main board or separate boards?
