crwdns2942213:0crwdne2942213:0
-
-
Remove the magnetic ear pads by gently pulling up away from the head set.
-
-
-
Squeeze the plastic opening tool between the black plastic and foam pad on non mic side and then pry upwards to remove the felt pads covering the speaker.
-
-
-
Remove the four 6mm Phillips 1 screws.
-
-
-
-
Lift the speaker module up off the device.
-
-
-
Remove the four 6mm Phillips 1 screws.
-
-
-
Use a soldering iron to desolder the black and yellow wires from the two metal plates near the bottom of the device.
-
Use a soldering iron to desolder the 13 wires in rows along the left and bottom sides of the headset motherboard.
-
-
-
Use the plastic opening tool to pry off the black tape covering the gray wires
Thank god I have been looking for this one for a while thank you guys.
i have i problem with my microphone see in step 7 there are two wires for the microphone ( green and copper color)near the microphone screw, in my headset the copper one dose not connected with the green any idea how to connect them together?
-
-
-
Lift the motherboard out of the headset and gently disconnect the gray wires from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S15-G1, Livingston Fall 2017 crwdns2935289:0Cal Poly, Team S15-G1, Livingston Fall 2017crwdne2935289:0
CPSU-LIVINGSTON-F17S15G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:010crwdne2935297:0
crwdns2947412:02crwdne2947412:0
Any chance I could get the E250336. USB board part from you guys? I need one.
I am having a very tough time finding this Part online. Thanks!
