crwdns2915892:0crwdne2915892:0
Make sure the cord is unplugged.
crwdns2942213:0crwdne2942213:0
-
-
-
Remove the orange main housing unit from the vacuum bucket by pulling outward on the handle tabs while lifting upward as shown.
crwdns2952109:0crwdne2952109:0
-
-
-
Remove the five 15mm PH2 screws.
-
-
-
Remove the 15 mm T20 screw. This screw is located nearest the power cord.
-
-
-
Gently separate the upper and lower sections of the main housing.
-
-
-
-
-
-
Using a PH2 screw head, unscrew the two 15mm screws as shown.
-
-
-
Pull the black handle.
-
Using a PH2 screwdriver, unscrew the single 12mm screw shown.
-
-
-
Use the blue opening tool to open up the black handle.
-
-
-
Using your fingers, gently take out the black cords.
-
-
-
Using the spudger, take out the switch. Do this by pushing the spudger against the switch on both sides as shown and then pull the switch out.
-
-
-
Replace the switch shown.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2935287:0crwdne2935287:0
IUPUI, Team 2-1, Baechle Spring 2016 crwdns2935289:0IUPUI, Team 2-1, Baechle Spring 2016crwdne2935289:0
IUPUI-BAECHLE-S16S2G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:047crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Any idea where to find a replacement switch? I did not see one on Amazon or eBay.
Mitchell Taylor - crwdns2934203:0crwdne2934203:0 crwdns2950251:0crwdne2950251:0
