crwdns2942213:0crwdne2942213:0
-
-
Place the Lisa on a safe/sturdy surface.
-
-
-
Press the two tabs underneath to release the panel.
-
-
-
Release the thumbscrew underneath the drive cage and the cage will pull out. Disconnect drive wires while the cage is being removed.
-
-
-
Twist thumbscrews on the back to release the panel. Pull panel up to remove.
-
-
-
Release the thumbscrew on the power supply. Pull out the power supply.
-
-
-
-
Grab the card cage at the location shown and pull out.
-
-
-
Unscrew two philips screws on the ceiling of where the card cage was.
-
-
-
Release two screws and release the ribbon cable.
-
-
-
Remove all screws shown.
-
-
-
Remove all screws shown.
-
-
-
Remove all screws shown.
-
-
-
Remove all screws shown.
-
-
-
I am not a certified CRT technician so I am not suppling steps on how to remove it although here is a photo of the innards.
-
-
-
Pull up on the tabs to remove cards.
-
-
-
Remove all screws shown.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0