crwdns2915892:0crwdne2915892:0
Use this guide to access the internal components of an Anker Soundcore Motion Boom Plus.
crwdns2942213:0crwdne2942213:0
-
-
Insert an opening tool into the seam between the speaker grille and the chassis.
-
Pry the tool around the top, bottom, and sides until the grille fully releases.
-
Remove the grille.
-
-
-
Remove the two passive radiators on either side of the device.
-
-
-
Remove the sixteen 14 mm Phillips screws, eight on each end of the speaker.
-
-
-
Gently remove the handle from the device by clicking off the handles from the sides and then pulling it off.
-
-
-
-
Flip the speaker onto its side and use a spudger to remove the two rubber feet on the bottom of the device.
-
-
-
Remove the eleven 13 mm Philips screws that secure the driver housing.
-
-
-
Remove the two 14 mm Phillips screws located on each side of the handle, near the clip points.
-
-
-
Remove the four 14 mm Philips screws on the top of the device.
-
-
-
Insert a spudger into the seam on top of the device.
-
Gently pry the casing open.
-
-
-
Disconnect each of the three cables by gently pulling the connectors out of their sockets.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.