crwdns2915892:0crwdne2915892:0
The speaker of your Anbernic RG 40XXV produces audio for gaming. In cases of extended use at a high volume, the speaker may require replacement.
This guide will walk you through replacing the speaker of your device to resume gameplay with audio.
Before beginning this guide, ensure your Anbernic RG 40XXV is fully powered off and disconnected from the charger.
crwdns2942213:0crwdne2942213:0
-
-
Remove the micro SD card located on the left and right sides of the device by pushing into the SD card slot and pulling the card out.
-
Unscrew all six 7.5 mm screws on the backside of the case using a 1.5 mm hex screwdriver.
-
-
-
Take apart the case by separating the front and back sides using an iFixit opening tool.
-
-
-
Disconnect the battery connection cable by gently pulling it away with angled tweezers from the slot that connects the cable to the motherboard.
-
-
-
-
Using a Phillips #00 screwdriver, remove the 10 5.5 mm screws securing the circuit board to the case.
-
-
-
Remove the tape covering the ribbon cables.
-
Using ESD-safe tweezers, gently pull the ribbon cables away from the circuit board.
-
-
-
Gently lift the circuit board out of the case.
-
-
-
Using ESD-safe tweezers, gently pull the speaker out of the case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Idaho State University, Team 1-2, Watkins Spring 2025 crwdns2935289:0Idaho State University, Team 1-2, Watkins Spring 2025crwdne2935289:0
ISU-WATKINS-S25S1G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
