crwdns2915892:0crwdne2915892:0
Use this guide to remove or replace a driver pad on a Clarke Floor Sander 07163A 2017.
This guide shows the removal of just one pad, but the procedure for the other two pads is identical.
crwdns2942213:0crwdne2942213:0
-
-
Carefully tilt the sander back and lay it down on its side, exposing the three sanding pads on the bottom.
-
-
-
-
Peel the hook-and-loop sandpaper disc off of the driver assembly.
-
-
-
Use a 3 mm hex key or driver bit to remove the six 11.9 mm-long screws securing the driver pad.
-
Remove the driver pad from the sanding disc.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2947410:01crwdne2947410:0
replace all three driver pads
