crwdns2942213:0crwdne2942213:0
-
-
When Prying the bottom off, insert the Metal Spudger under the bottom where the ports are
-
Avoid letting the Adhesive touch anything, lay the plate on the branded side
-
If the adhesive is to strong use a hair dryer to soften it
-
-
-
Use a TORX T6H bit to remove the four screws on the bottom
-
When all the screws are taken out lift up and the covering should slide off
-
-
-
-
Remember to un latch the ribbon cable before pulling the circuit board up
-
-
-
To get the further screws on the bottom, use a 4 mm nut driver and put the TORX bit in the nut driver as an extension
-
Pull up on the metal to release the top from the rest
-
-
-
Undo the four screws the remove the white defuser piece (I lost a screw)
What type of plastic is the defuser plate? I am thinking about painting it so the ring won't be so bright at night. Its a shame there is no night mode toggle to lessen the brightness.
-
-
-
The two should separate if you hold the edge, if it doesn't push a button on top and it should pop out
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:05crwdne2935229:0
crwdns2947412:02crwdne2947412:0
Parabéns pelo tutoria de desmontagem do aparelho ALEXA ECHO DOT 3ª geração! Excelente trabalho!!!
Eu recebi um aparelho desse para efetuar a manutenção, pois este estavatotalmente inoperante, por dois motivos:
1° ADAPTADOR FONTE AVARIADO, gerando tensão de saída DC oscilante;
2° MAL-CONTATO NO CABO FLEXÍVEL INTERNO que conecta as duas placas eletrônicas internas.
How can I convert Amazon Echo Dot power from AC to DC?
