crwdns2915892:0crwdne2915892:0
Use this guide to replace the logic board in your Alcatel Jitterbug Smart
crwdns2942213:0crwdne2942213:0
-
-
Pry back cover open with a medal spudger, or your fingernail, in the divot at the bottom left corner of the phone.
-
Lift open case by the corner nearest the divot and remove it from the phone.
-
-
-
Remove the 13 1 mm Phillips screws with JIS #000 Screwdriver.
-
-
-
-
Gently pry off the Mid frame from the phone using a Metal Spudger.
-
-
-
Use the Plastic Opening tools to gently dislodge the broken camera from the inside of the phone.
-
Use a tweezers to pull the camera connector from its port.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.