crwdns2915892:0crwdne2915892:0
Use this guide to properly remove the face plate from the chassis without damaging any of the components on the inside.
crwdns2942213:0crwdne2942213:0
-
-
Remove all the selector knob covers by pulling them off.
-
-
-
Using needle nose pliers, remove the washers from the four corner selector knobs.
-
-
-
-
Flip the device over. Using a Philips #2 screw driver, remove the fourteen 10.3 mm black screws holding the back panel in place.
-
-
-
Carefully flip the device to the front making sure you secure the face plate and the chassis together.
-
-
-
Rotate the device 180 degrees and carefully remove the face plate by slightly lifting the screen side towards you and then sliding the bottom out from under the keys.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0