crwdns2915892:0crwdne2915892:0
After removing the Secondary Board on your device you should be exposed to the speaker. Now you are able to remove them. As a precautions ground yourself to prevent frying the internal components. Also make sure to keep track of screws and label them.
crwdns2942213:0crwdne2942213:0
-
-
Use the plastic tool to pry between the silver bezel and the back case
-
Work the tool around the device to free the back case
-
-
-
Remove the ribbon cables by lifting up the white retaining flap on the ZIF connectors, then pulling the ribbon cable away.
-
-
-
Remove the battery connector by prying it up away from the device using 2 plastic pry tools
-
-
-
Remove all 9 of the 1.5mm #00 Philips screws
-
Gently lift the battery out of the device
-
Use an opening pick or similar tool to separate the adhesive on the bottom and top of the battery.
-
-
-
Use a plastic opening tool to lift the black retaining flap on the ZIF Connector
-
-
-
Use a tweezers to lift out the camera
-
-
-
Using the plastic prying tool, lift the small retaining flap on the ZIF Connectors holding the ribbon cables to the motherboard
-
-
-
-
Using the tweezers remove the connector gently from the yellow slot
-
Gently peel up the tape until is is completely released from the motherboard
-
-
-
Cut the warranty tape connecting the motherboard to the metal plate under the battery
-
-
-
Using the #00 Phillips head screwdriver, remove the remaining 1.5mm screws in the motherboard
-
-
-
Gently lift the motherboard from your device
-
-
-
To remove the ribbon cables, lift up the white retaining flap on the ZIF Connectors with a plastic pry tool
-
-
-
Using the tweezers gently pull off the tape over the ribbon cable
-
-
-
Using the tweezers gently pull the ribbon cable out from from the connector.
-
-
-
Using the tweezers gently remove the connector from the yellow slot
-
-
-
Cut the warranty tape connecting the daughter board to the metal plate under the battery
-
-
-
Using the #00 Phillips head screwdriver, remove the remaining 1.5mm screws in the daughter board
-
Gently lift the daughter board from the device
-
-
-
Gently lift up the speaker to remove it from the device
-
-
-
Using the #00 Phillips head screwdriver, remove the 1.5mm screws
-
Gently lift up the second speaker to remove it from the device
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 2-2, Cagle Fall 2016 crwdns2935289:0USF Tampa, Team 2-2, Cagle Fall 2016crwdne2935289:0
USFT-CAGLE-F16S2G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
