crwdns2915892:0crwdne2915892:0
Pay attention to your device as you disassemble so that you can successfully reassemble later.
crwdns2942213:0crwdne2942213:0
-
-
Gently pry the back hinge cover piece away from the device.
-
-
-
Disconnect the speaker cable from the motherboard.
-
-
-
Lift the screw cover and remove the screw using a Phillips #0 screwdriver.
-
-
-
Remove the RAM cover by lifting the screw cover and pulling away firmly.
-
-
-
Push outwards on the clips to release the RAM stick. The stick should pop up at an angle.
-
-
-
-
Repeat steps 3-4 to remove the second RAM stick.
-
-
-
Remove the two screws from underneath the RAM cover.
-
-
-
Remove all of the screws from the bottom of the case.
-
If replacing the screen, remove the rubber feet to reveal two more screws.
-
-
-
Turn the laptop over and remove the screws as shown
-
-
-
Carefully pry the keyboard away using your spudger and the opening tools.
-
-
-
Detach the ribbon cable by releasing the clip
-
-
-
Remove screws from silver braces.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use tweezers to remove golden screw caps.
-
-
-
Remove tape and gently pull up on golden cap connectors to disconnect them.
-
-
-
Gently pull the white connector until it comes loose.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0