crwdns2915892:0crwdne2915892:0
If your ANKER SoundCore does not charge, your charging port may be broken. If you wish to replace your device’s charging port, you can follow this step-by-step guide.
Before attempting to replace anything, it is recommended that you look at this device’s troubleshooting guide.
You will need an iFixit opening tool, Phillips #0 screwdriver, metal spludger, and iFixit opening pick. Soldering experience is needed.
crwdns2942213:0crwdne2942213:0
-
-
Use the plastic opening tool to pry off the screen.
-
Remove the screen from the device.
-
-
-
Remove the eight 10 mm Phillips #0 screws from the speaker mount.
-
-
-
Use the metal spludger to pry off speaker mount.
-
-
-
-
Remove the two 8mm Phillips #0 screws from the circuit board.
-
-
-
Carefully remove the circuit board from the speaker body.
-
-
-
Use the iFixit Opening Pick to pry off the charging port cover.
-
Remove the charging port cover.
-
-
-
Desolder the charging port from the circuit board.
-
Solder a new charging port in place of the old one.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S22-G1, Regan Winter 2020 crwdns2935289:0Cal Poly, Team S22-G1, Regan Winter 2020crwdne2935289:0
CPSU-REGAN-W20S22G1
crwdns2931471:05crwdne2931471:0
crwdns2935297:06crwdne2935297:0
crwdns2944067:04crwdne2944067:0
Where can I find a replacement port that is compatible?
Where can I find a replacement port that is compatible?
The Charging port is an USB Mirco Port. To find right part search for JBL FLIP 3 on ebay or other platforms. It is the same part as used for the Anker SoundCore.
Agi -
Hi I have a Anker soundcore motion plus, the charging port is loose and not charging, it's a usb c, where can I buy that replacement part
.thanks
