crwdns2915892:0crwdne2915892:0
The 360fly is a lens, camera, and storage device all in one. Its internal battery and 32GB memory give users the power to capture approximately 2 hours of 360° HD footage each time out.
This lightweight camera provides everything users need to take entire surroundings from a single digital unit.
- Powerful 16-megapixel image sensor and 4K video resolution 2880 x 2880 pixels up to 30 fps.
- Eight glass element ultra-fish-eye lens is used to capture 360-degree video.
If you are unable to clearly capture an image or the lens has been damaged in some way, follow this guide to replace the lens.
crwdns2942213:0crwdne2942213:0
-
-
Flip the camera upside down and peel off the two plastic screw covers with the metal spudger to reveal the screws.
-
-
-
Remove the two 5 mm screws from the bottom of the camera with a T4 screwdriver.
-
-
-
Gently pry the plastic ring from around the charging plate with the metal spudger.
-
Remove the outside shell by pressing against the center of the charging plate and pulling the bottom shell away from the top shell.
-
-
-
Remove the five 2 mm screws using a T4 screwdriver.
-
Pull off the charging plate assembly.
-
-
-
-
Gently pry the plug off the port on the circuit board with a plastic opening tool.
-
Remove the four 2 mm screws using a T4 screwdriver.
-
Remove the circuit board from the device.
-
-
-
Remove the five 4 mm screws around the battery assembly with a T4 screwdriver.
-
Lift the battery assembly and gently pry the plug out of its port on the board below with a plastic opening tool.
-
Press the battery from the back of the battery assembly to remove it with a plastic opening tool until the glue releases the battery.
-
-
-
Gently pry the plug from the motherboard and remove the motherboard from the assembly.
-
-
-
Remove the three 3 mm screws from the circuit assembly with a T4 screwdriver.
-
-
-
Gently pry out the plug from the circuit assembly.
-
-
-
Press and release the SD card to remove it from the circuit assembly.
-
-
-
Unscrew the five 3mm screws with a T4 screwdriver.
-
-
-
Gently push against the lens module to remove it from the 360fly 4K assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team S5-G3, Baechle Fall 2017 crwdns2935289:0IUPUI, Team S5-G3, Baechle Fall 2017crwdne2935289:0
IUPUI-BAECHLE-F17S5G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
crwdns2944067:04crwdne2944067:0
Hi. Where to get a replacement lens as I am in need for this repair, but 360fly offer a full service for $150 and do not sell spare lenses. Thx
There is no info where to buy the replacement lens.
Anyone know about usb pinout? I lost my charger adapter
Hi.
I inadvertently found your question.
I have this same problem.
I've lost the charger, too, and now I'm looking for a chance to charge without a base, or a chance to buy a base.
Imants
Imants R -
