crwdns2915892:0crwdne2915892:0
Replacing a 2011 Jeep Liberty hood is a moderately simple task, requiring only a single tool. It is recommended to have two people complete the replacement, though it is not a requirement. There are no special skills required for this replacement. Replacing the hood is usually a cosmetic choice but may be needed if the hood is misshapen and will not longer function with the vehicle.
crwdns2942213:0crwdne2942213:0
-
-
Open the hood of the Jeep by pulling the hood latch. This is placed right next to the driver's seat and to the left of the brake pedal.
-
-
-
Notice a latch located above the car's grill after popping the hood. Lift the hood by releasing the latch. After lifting the hood, notice a movable latch just above the wiper fluid container. There is a specific hole on the left side of the hood where you can hook the latch.
-
-
-
-
Disconnect the wind-shield fluid line on the left side of the hood.
-
-
-
Identify the four bolts which can be seen towards the extreme left (2 bolts) and extreme right (2 bolts) underneath the hood.
-
-
-
Remove the four bolts using a 13mm wrench and lift the hood out of place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team S1-G20, Sinclaire Spring 2021 crwdns2935289:0UMass Dartmouth, Team S1-G20, Sinclaire Spring 2021crwdne2935289:0
UMASSD-SINCLAIRE-S21S1G20
crwdns2931471:02crwdne2931471:0
crwdns2935303:01crwdne2935303:0
