crwdns2915892:0crwdne2915892:0
This guide will show how to replace a dead or dying battery in a Honda Shadow Spirit motorbike. All tools should be included in the motorbike in the tool box.
NOTE: The directions in the guide refer to the view from the back of the motorbike.
Left = The side opposite the tail pipe
Right = The side with the tail pipe
crwdns2942213:0crwdne2942213:0
-
-
Remove the plastic covering, located on the left side of the bike, by pulling the piece straight off the bike.
-
-
-
The tool box is located under the panel.
-
Using the key to the motorbike, unlock the tool box.
-
Remove the plastic bag inside holding the tools needed for basic maintenance for the motorbike.
-
-
-
Using the allen wrench, remove the screws on both sides of the bike seat.
-
-
-
-
Pull the rear of the seat upwards.
-
Pull the seat backwards to remove it from the bike.
-
-
-
Using the screwdriver, remove the screw holding the plastic cover.
-
-
-
Pull the cover off the battery and remove the fuse box from the cover.
-
Place the fuse box over to the side right of the bike. Do not disconnect the wires.
-
-
-
Using the screwdriver, remove the ground wire (negative (-) cable) from the battery.
-
Place the wire over the left side of the bike.
-
-
-
Also using the screwdriver, remove the positive (+) cable from the battery.
-
Place the wire over the right side of the bike.
-
-
-
Remove the battery from the bike by pulling upwards.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:09crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 1-7, Donnelly Fall 2014 crwdns2935289:0USF Tampa, Team 1-7, Donnelly Fall 2014crwdne2935289:0
USFT-DONNELLY-F14S1G7
crwdns2934841:01crwdne2934841:0
crwdns2935297:02crwdne2935297:0
