iPhone X slightly bent, Solder two layers together
How do I solder two layers back together when the top layer is slightly bent at the top?
Thanks in advance!
crwdns2934109:0crwdne2934109:0
How do I solder two layers back together when the top layer is slightly bent at the top?
Thanks in advance!
crwdns2934109:0crwdne2934109:0
If it is the front of the board that isn’t connecting I wouldn’t be too worried as they are all ground pads. If it is bent significantly you will need to solder the spacers back on and clamp it down while heating.
I think there are about 8 spacers. You might have to get them from an unseparated IC board if you haven’t saved any from the other boards.
crwdns2934105:0crwdne2934105:0
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 1
crwdns2936753:030crwdne2936753:0 1
crwdns2942667:0crwdne2942667:0 51
crwdns2942205:01crwdne2942205:0
@iammyron07 two layers of what? Has the screen separated or the logic board? Give us more detail
crwdns2934271:0crwdnd2934271:0 oldturkey03 crwdne2934271:0