crwdns2934065:0crwdne2934065:0: 35
1
1
I have a 2003 honda accord coupe, no leaks in the transmission at all. When I start to drive the car it takes a lot to get going but after if moves just fine. No problem in shifting and the reverse is good too. Is it the pressure control solenoid valve?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 782.1crwdns2936485:0crwdne2936485:0
1.1crwdns2936485:0crwdne2936485:0
893
2.3crwdns2936485:0crwdne2936485:0
Dexter Murphy, error code P0962=Pressure Control Solenoid A Control Circuit Low. Had the same happening on my jeep and required me to replace the Solenoid. There is a great flow chart fault finder on here I know it does say civic but the error is the same :-)I also attached an image for the transmission and the solenoid is shown as #4 and sits on the outside of your transmission. Good Luck and I hope you get it done.
crwdns2934105:0crwdne2934105:0
Thanks oldturkey03 for all your help. I get the part in tomorrow. I pray this is it. Have a great day
thank you for accepting my answer and I hope that you get your error code resolved with the new part. BTW my jeep had the same error code and would not shift gears and drove horrible, after changing a $40 solenoid inside the tranny, drives like new. So we'll keep our fingers crossed...Good Luck
crwdns2936751:024crwdne2936751:0 2
crwdns2936753:07crwdne2936753:0 14
crwdns2936753:030crwdne2936753:0 34
crwdns2942667:0crwdne2942667:0 8,719
