I plugged my 110v hand blender in a 220v power source. It made a flash, and never turned on again, so we can assume its burned, right?
What exactly was damaged?
Is it possible to fix it?
How?
Where do I buy the parts needed to do it?
crwdns2934109:0crwdne2934109:0
crwdns2934065:0crwdne2934065:0: 781.5crwdns2936485:0crwdne2936485:0
1.1crwdns2936485:0crwdne2936485:0
893
2.3crwdns2936485:0crwdne2936485:0
pedro, the only way to determine exactly what has overloaded is by taking the blender apart. Most likely it is the caps (potentially a fuse on a circuit board) or even the motor. But, you'll have to take it apart to see what needs to be replaced.
crwdns2934105:0crwdne2934105:0
Hi oldturkey!
Thank you for your message!
So do you think I should take it apart? I am not very experienced in doing stuff like that, but, on the other hand, I don't think I have another choice...
I will open it and post the photos soon!
I definitely would take it apart. Take lots of pictures so you know what goes where. then take a couple of hi-res images of the electronic components and post those to keep us informed.
hi dude, i did the same. could u pl tell what happened to the motor and how to solve the issue
crwdns2936751:024crwdne2936751:0 0
crwdns2936753:07crwdne2936753:0 1
crwdns2936753:030crwdne2936753:0 1
crwdns2942667:0crwdne2942667:0 1,138
crwdns2942205:01crwdne2942205:0
hi dude, i did the same. could u pl tell what happened to the motor and how to solve the issue
crwdns2934271:0crwdnd2934271:0 sunil gupta crwdne2934271:0