Logic board solder pad repair?
Hi,
HELP HELP HELP!
In an attempt to replace a fpc connector I have managed to damage solder pad (contact) on the logic board of an ipad 2.
What's the best way to go about repairing surface mount inorder to put in the new fpc connector.
Any advise would be much appreciated!
Thank you
Nikki
crwdns2934109:0crwdne2934109:0
crwdns2944067:02crwdne2944067:0
Post a picture Nikki, we can help you figure out where to run a fine wire jumper to bring flow back to this pin.
crwdns2934271:0crwdnd2934271:0 jessabethany crwdne2934271:0
Done.
As you can see it is quiet bad :(
crwdns2934271:0crwdnd2934271:0 Nikki crwdne2934271:0