crwdns2933423:0crwdne2933423:0
crwdns2934055:0crwdne2934055:0

Replacing HD Step 13 calls for Torx T6

Following your instructions for the removal/replacement of the HD

PowerBook G4 Aluminum 12" 1-1.5 GHz Hard Drive Replacement

at Step 13 it indicates that there are 2 hex screws. I have a Torx T6 driver but it just spins in those screws.

Any recommendations on how to get those screws out (and back in)?

crwdns2934081:0crwdne2934081:0 crwdns2934083:0crwdne2934083:0 crwdns2934093:0crwdne2934093:0

crwdns2934109:0crwdne2934109:0

crwdns2889612:0crwdne2889612:0 0
crwdns2934285:0crwdne2934285:0

crwdns2933313:01crwdne2933313:0

crwdns2934051:0crwdne2934051:0

On the comments area beneath steps 9 to 16:

"I found that a T7 Torx screwdriver worked better for removing the two hex screws" slessard, Nov 7 2009 @ 2:33 PM

crwdns2934105:0crwdne2934105:0

crwdns2889612:0crwdne2889612:0 0
crwdns2934285:0crwdne2934285:0
crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 0

crwdns2936753:07crwdne2936753:0 0

crwdns2936753:030crwdne2936753:0 0

crwdns2942667:0crwdne2942667:0 318