crwdns2934243:0crwdne2934243:0 oldturkey03 crwdns2934247:0crwdne2934247:0

crwdns2947189:0crwdne2947189:0:

Removing digitizer glue residue

crwdns2934249:0crwdne2934249:0:

I have an iPad2 on which the digitizer was completely shattered and had to be removed piece by piece. I've done this but there is a lot of glue residue left all around the edge of the device. I have the 3M glue pads and I'm ready to install the new digitizer, but I want to remove all the old glue first, some of which still has somevery fine glass shards stuck to it. Is there a solvent I can use to achive this without damaging the device? If not, is there a way to do this so that I've got a clean surface to apply the new glue pads to?

crwdns2866306:0crwdne2866306:0:

iPad 2 Wi-Fi EMC 2415

crwdns2915684:0crwdne2915684:0:

open

crwdns2934251:0crwdne2934251:0:

crwdns2934245:0crwdne2934245:0 iRobot

crwdns2947189:0crwdne2947189:0:

Removing digitizer glue residue

crwdns2934249:0crwdne2934249:0:

I have an iPad2 on which the digitizer was completely shattered and had to be removed piece by piece. I've done this but there is a lot of glue residue left all around the edge of the device. I have the 3M glue pads and I'm ready to install the new digitizer, but I want to remove all the old glue first, some of which still has somevery fine glass shards stuck to it. Is there a solvent I can use to achive this without damaging the device? If not, is there a way to do this so that I've got a clean surface to apply the new glue pads to?

crwdns2866306:0crwdne2866306:0:

crwdns2915684:0crwdne2915684:0:

open

crwdns2934241:0crwdne2934241:0 Simon

crwdns2947189:0crwdne2947189:0:

Removing digitizer glue residue

crwdns2934249:0crwdne2934249:0:

I have an iPad2 on which the digitizer was completely shattered and had to be removed piece by piece. I've done this but there is a lot of glue residue left all around the edge of the device. I have the 3M glue pads and I'm ready to install the new digitizer, but I want to remove all the old glue first, some of which still has somevery fine glass shards stuck to it. Is there a solvent I can use to achive this without damaging the device? If not, is there a way to do this so that I've got a clean surface to apply the new glue pads to?

crwdns2866306:0crwdne2866306:0:

iPad 2 Wi-Fi

crwdns2915684:0crwdne2915684:0:

open