To access the switch module.[br]
Remove the two small Philips screws on the bottom of the Toaster below the switch section,[br]
Remove the two small Philips screws above the switch section, under /behind the Toaster Door.[br]
The Door will now come off.[br]
Then remove the two side panels that sit behind the Door. Again 4 Philips screws .[br]
At this point the whole bottom section will be loose.[br]
[br]
It is held in place by two Z shaped bracket that tie this section to the main Toaster body .[br]
Wiggle it ..it will come out .[br]
[br]
At this point you have to remove ALL the large Philips screws that hold the Relay circuit board to the Switch LED Board below.[br]
Do NOT remove any wires, there is NO need .[br]
Then remove ALL the Philips screws holding the Switch LED board to the Plastic Front plate / Cover .[br]
[br]
You can now play with the Toaster Micro switch .[br]
Good Luck.