Check that the door latch strike is operating the door switch.
If the switch is not operating the machine won't start.
Here's the wiring diagram that may help.
Disconnect the power to the dishwasher and then access the control board and use an Ohmmeter to check for continuity between the P1 and P3/6 terminals on the control board when the door is shut.
[image|3557727]
(click on image)
+
+
=== Update (02/28/25) ===
+
Hi @ivanblackford
+
+
Here's the [document|41242|service data sheet] for the dishwasher.
+
+
Check if you can run the ''water/service test'' as described and see if that isolates the problem any further.
+
+
Another option perhaps is to check if there any fractures in the wires of the harness at the bottom of the door where they go from the control panel into the rest of the machine.
Hi @ivanblackford
Check that the door latch strike is operating the door switch.
If the switch is not operating the machine won't start.
Here's the wiring diagram that may help.
Disconnect the power to the dishwasher and then access the control board and use an Ohmmeter to check for continuity between the P1 and P3/6 terminals on the control board when the door is shut.
[image|3557727]
(click on image)