I'm trying to determine if the water level/temp controller (#W10248240 REv. G) is bad on my Maytag MVWC6ESWW1 washer. All cycles run normally except drain. The drain cycle runs for about 5 seconds, stops for 3 to 5 minutes, the repeats until the tub is drained. Then the next wash cycle starts and runs normally until the next drain cycle where the problem repeats. All drain hoses, internal and external, are clear all the way back to the pump. Lid switch is good. Any suggestions?
I'm trying to determine if the water level/temp controller (#W10248240 REv. G) is bad on my Maytag MVWC6ESWW1 washer. All cycles run normally except drain. The drain cycle runs for about 5 seconds, stops for 3 to 5 minutes, the repeats until the tub is drained. Then the next wash cycle starts and runs normally until the next drain cycle where the problem repeats. All drain hoses, internal and external, are clear all the way back to the pump. Lid switch is good. Any suggestions?