Soldering tip not recognized when powering on the iron
crwdns2934249:0crwdne2934249:0:
Dear all,[br]
[br]
my hub is running on firmware 1.06 it starts up normally and recognizes the tip in the iron:[br]
[br]
When I switch the iron itself on, the hubs suddenly says that there is no tip connected.[br]
[br]
Switching the hub off and on again leaving the iron in the same port shows the same error.[br]
[br]
When I plug the iron to the other port and cycle power of the hub, it works until the next restart of the hub.[br]
[br]
I already tried another tip but that didn´s solve the problem:[br]
[br]
Do you have any idea what to do?[br]
[br]
Best regards[br]
[br]
Andreas
Soldering tip not recognized when powering on the iron
crwdns2934249:0crwdne2934249:0:
Dear all,[br]
[br]
my hub is running on firmware 1.06 it starts up normally and recognizes the tip in the iron:[br]
[br]
When I switch the iron itself on, the hubs suddenly says that there is no tip connected.[br]
[br]
Switching the hub off and on again leaving the iron in the same port shows the same error.[br]
[br]
When I plug the iron to the other port and cycle power of the hub, it works until the next restart of the hub.[br]
[br]
I already tried another tip but that didn´s solve the problem:[br]
[br]
Do you have any idea what to do?[br]
[br]
Best regards[br]
[br]
Andreas