SOLVED WON'T TURN ON - LG - 34UM95-P UltraWide
* steps for glory ********
* buy CH341A programmer with clamp, you will connect the clamp on the USB on 25 socket, check picture (it has 24 and 25, connect in the direction of picture below)
* you will reprogram the chip EEPROM (BIOS) ML25L8006E - using the USB, the CLAMP, a software and a PC with windows
* unplug your monitor LG 34UM95-P from wall 19V adapter
0-connect USB Programmer with clam on the chip correctly in pin 1 on the motherboard of the monitor LG 34um95-p
0b. LG monitor should be UNNPLUGED (not with 19v connected) - RED light on dongle will ON
1- INSTALL DRIVER WITH USB PROGRAMMER CONNECTED TO YOUR PC AND WITH SUCCESSFULL INSTALL
2- on software select DETECT
if ok will detect a few variations
3- SELECT ONLY ML25L8006E FOR LG 34UM95-P MONITOR
4 - READ: if ok will read actual firmware (100%) -- GREEN light on USB dongle will flash
5- SAVE: BACKUP OF ACTUAL FIRMWARE on your PC
6- press ERASE, then BLANK
7-READ AGAIN, you will see all FF and ...... of blank memory of the EEPROM CHIP
8 - OPEN and select NEW firmware working (from link) LG 34um95-p.bin
9- press WRITE ( and wait 100%) this will write new firmware
10-disconnect usb dongle from your pc
11-PLUG the monitor with 19v power adapter
12- it shoul work and POWER ON!!! :)))
software https://tecmikro.com/documentos-software/Programador-CH341A.zip
firmware working LG 34um95-p.bin https://www.badcaps.net/filedata/fetch?id=2071192
[image|3431628]
[image|3431625]
[image|3431627]
[image|3431629]
this is another exampled how to use USB (in this case on a motherboard pc)
[image|3431631]